Dell 7 beeps error

£0.00

In most Dell laptops, 7 beeps indicates to processor failure.You may follow these steps if you are comfortable in opening up the system: 1. Remove main battery. 2. The bottom plate for the system 3. With the battery compartment nearest to you in the top left corner you will see the CMOS battery. 4. Using a minimal amount of force and a flat tool, pry the battery gently from its seat (it is held on by sticky substance). 5. Unplug the battery from the motherboard by disconnecting the white connector. 6. Wait for two to five minutes and then reattach the battery cable and reseat the battery. 7. Replace the rear plate and the retaining screws and reseat the main battery. 8. Attach the AC adapter and power on the system. 9. If a 5 beep code is heard, switch off the system and restart it. 10. When the system restarts and completes POST successfully, browse to the Drivers and Downloads page. http://dell.to/Sd9ofv 11. Download and install the latest BIOS Version. If you do not wish to perform the above steps, then you may try performing Pre Boot System Assessment (PSA Diagnostic) by holding the “Fn” while rebooting the system. Keep holding "Fn” key until the diagnostic gets initiated. Please refer to the link below for details: http://dell.to/oe1Qg1

OUT OF STOCK - call to enquire

Manufacturers
Website Visits
153,805,267
visitors since Saturday 10 May, 2008
We Accept
Currencies